Trailing arm dimension with pic
Thread Starter
2026 Loser of the Year
Joined: Sep 2013
Posts: 36,521
Likes: 6,987
From: New Or-leens Loo-z-anna
I'll get right on it......probably a 1 & 1/2 hour job.....as fast as I'm getting with trailing arms..........
EDIT: I just realized that I could have asked Uncle Bubba to bend a 20* angle in each strut rod which would have gotten the Camber and Toe within tolerance....then I wouldn't have to remove the trailing arms/"straighten" them/Remove them again/"straighten according to the measurements that the members provided/Re-install them/Re-set camber and Toe ON ONE ARM so far.....Whew!
EDIT: I just realized that I could have asked Uncle Bubba to bend a 20* angle in each strut rod which would have gotten the Camber and Toe within tolerance....then I wouldn't have to remove the trailing arms/"straighten" them/Remove them again/"straighten according to the measurements that the members provided/Re-install them/Re-set camber and Toe ON ONE ARM so far.....Whew!
Last edited by doorgunner; May 18, 2014 at 05:07 PM.
