Align Nozzle With Dot
#1
Melting Slicks
Thread Starter
Member Since: Apr 2009
Location: Great Plains Iowa
Posts: 2,632
Likes: 0
Received 114 Likes
on
108 Posts
Align Nozzle With Dot
Many years ago all of the spray paint can's instructions said "Align Nozzle With Dot" but then somewhere along the line they quit saying that. If you'll notice there is a black dot near the nozzle and you're supposed to align the opening of the nozzle with that dot. Inside the can is a bent plastic tube that attaches to the underside of the nozzle and then it curves down and touches the bottom edge of the can directly under that black dot; the purpose being so all of the paint can be used when pointing the can either straight ahead or down at an angle
So how many of you old timers knew what that black dot was for?
So how many of you old timers knew what that black dot was for?
Popular Reply
11-30-2015, 07:17 PM
Administrator
Member Since: Jul 2000
Location: About 1100 miles from where I call home. Blue lives matter.
Posts: 51,391
Received 5,323 Likes
on
2,772 Posts
Uh, no.
#2
Administrator
Member Since: Jul 2000
Location: About 1100 miles from where I call home. Blue lives matter.
Posts: 51,391
Received 5,323 Likes
on
2,772 Posts
Uh, no.
The following 12 users liked this post by vettebuyer6369:
7t2vette (11-30-2015),
C3 Stroker (11-30-2015),
COOLTED (12-01-2015),
havesometo (12-01-2015),
keithinspace (12-10-2015),
and 7 others liked this post.