Blinker Problems

Reply Subscribe

Thread Tools

Search this Thread

Mar 29, 2018 | 07:54 PM

samuel082799

Thread Starter

Advanced

Joined: Mar 2016

Posts: 69

Likes: 3

From: Poway California

Blinker Problems

I have a 1978 Corvette Pace Car, and I finished replacing the turn signal switch in the steering column. I then noticed when testing the blinkers it would blink for a few seconds and then go solid and then start blinking again. Now they are just not blinking they are solid all the time, but the hazards still blink continuously. I just replaced the hazard flasher, but it is still doing the same thing. All of the bulbs are relatively new so I dont know where to go from here. If anyone can point me in the right direction that will be greatly appreciated.

Mar 29, 2018 | 10:16 PM

righthanddrive

Pro

Joined: Dec 2015

Posts: 577

Likes: 107

From: colo

There are 2 flashers. One for hazards, and one for blinkers. I think the A.I.M. shows where they are located.

Mar 29, 2018 | 11:59 PM

samuel082799

Thread Starter

Advanced

Joined: Mar 2016

Posts: 69

Likes: 3

From: Poway California

Quote:

Originally Posted by righthanddrive

There are 2 flashers. One for hazards, and one for blinkers. I think the A.I.M. shows where they are located.

yeah, I got a new blinker flasher for the passenger side and that fixed it. Thanks

Mar 31, 2018 | 02:17 PM

henrikse

Pro

Joined: Nov 2016

Posts: 729

Likes: 118

From: Kelowna British Columbia

clean the bulb sockets all real good. A fiberglass pen works good or emery cloth. You can spray with contact cleaner. When indicator on steady usually lost connection to bulb.

Reply Subscribe

Thread Tools

Search this Thread

Show Printable Version

Email this Page

Reply Share

First
Prev
1 / 1
Next
Last

Forum Jump