1969 350 vacuum intake fitting
Thread Starter
Racer
Joined: Aug 2012
Posts: 251
Likes: 14
1969 350 vacuum intake fitting
Hey everybody, which vacuum intake fitting should my 1969 350/350 have? No power brakes, manual 4-speed non-air-conditioned. The assembly manual looks like a single port, but when I look at the Corvette vendors online the only single port that looks like it is for a 67?
Advanced
Joined: May 2020
Posts: 76
Likes: 7
From: MA
Hey everybody, which vacuum intake fitting should my 1969 350/350 have? No power brakes, manual 4-speed non-air-conditioned. The assembly manual looks like a single port, but when I look at the Corvette vendors online the only single port that looks like it is for a 67?
PS, obviously we are talking about Manifold (off the rear of the intake) and not Ported (off of the upper half of the Carb).
Last edited by 69lemans; Jan 1, 2021 at 03:03 PM.
Thread Starter
Racer
Joined: Aug 2012
Posts: 251
Likes: 14
My car is on the lift but if I recall, its a single port that goes to the tank. Maybe someone else can verify. I may have my car off the lift tomorrow if there are no other responses.
PS, obviously we are talking about Manifold (off the rear of the intake) and not Ported (off of the upper half of the Carb).
PS, obviously we are talking about Manifold (off the rear of the intake) and not Ported (off of the upper half of the Carb).
Race Director
Joined: May 2006
Posts: 18,692
Likes: 2,572
Thread Starter
Racer
Joined: Aug 2012
Posts: 251
Likes: 14
