Toms diff question correct yokes to half shaft

Reply Subscribe

Thread Tools

Search this Thread

Jan 27, 2022 | 04:48 PM

Donws

Thread Starter

Intermediate

Joined: Dec 2021

Posts: 48

Likes: 3

From: Jackson,NJ

Toms diff question correct yokes to half shaft

Hello, my new project came with a “Toms diff” but no axle yokes. The axle out of the diff is a round, flat pie plate size round steel plate with 8 holes, 4 for pressed in studs and 4 for 7/16 bolts. I’m trying to find what yoke mates with the half shaft u-joint. I called Toms “tech support” (its not) and the guy had no idea what I was talking about. I see 2 on their web site but not sure which is correct. Any clues would be appreciated,
Don

Jan 27, 2022 | 05:45 PM

76strokervette

Burning Brakes

Joined: Nov 2011

Posts: 1,170

Likes: 201

From: Willoughby Ohio

The Tom's set up uses either 1350 or 1480 yoke flanges from spicer. Most likely the 1350 variety but you can check pn to verify.

Jan 27, 2022 | 07:50 PM

GTR1999

Tech Contributor

Joined: Aug 1999

Posts: 15,175

Likes: 3,990

From: Connecticut, USA

Sounds like you have 1350 axles, the 1480 don't have dual bolt patterns. If the diff has been run hard you better look close at the axles and check the endplay

Jan 28, 2022 | 06:53 AM

Donws

Thread Starter

Intermediate

Joined: Dec 2021

Posts: 48

Likes: 3

From: Jackson,NJ

The car hasn’t run yet since the axle upgrade. Thanks for axle identifier.

Jan 28, 2022 | 08:12 AM

KC2X

Advanced

Joined: Jul 2011

Posts: 63

Likes: 19

From: Long Island, NY

Quote:

Originally Posted by GTR1999

Sounds like you have 1350 axles, the 1480 don't have dual bolt patterns. If the diff has been run hard you better look close at the axles and check the endplay

Welcome to the Forum,
GTR1999 is the authority on C2/C3 differentials. He can answer all your questions and assist you with your build. You might want to send him a PM with your contact info.
Kevin

Reply Subscribe

Reply Share

First
Prev
1 / 1
Next
Last

Forum Jump