ZZ4 350 ???????????????
#1
Racer
Thread Starter
Member Since: Oct 2001
Location: Monroe North Carolina
Posts: 412
Received 0 Likes
on
0 Posts
ZZ4 350 ???????????????
Is this manifold a square bore or a spreadbore? Also will my flywheel that i have on my 1973 350 L48 fit this engine? :confused:
#2
Team Owner
Re: ZZ4 350 ??????????????? (Corvettelvr73)
It will accept either square bore or spread bore. No your flywheel will not work. It has the new style 1 piece rear crank seal with a 3-inch bolthole pattern. Old 2-piece style cranks bolthole pattern is 3.58 inches.
Read this: https://www.corvetteforum.com/techti...=167&TopicID=3
Hopefully it will answer any of your questions.
John
[Modified by theandies, 10:33 AM 1/28/2003]
Read this: https://www.corvetteforum.com/techti...=167&TopicID=3
Hopefully it will answer any of your questions.
John
[Modified by theandies, 10:33 AM 1/28/2003]