Headers that will work
Thread Starter
Navigator
Joined: Jun 2002
Posts: 9
Likes: 0
From: Holland Michigan
Headers that will work
I recently installed some Brodix Track 1 heads on my small block '72 Corvette, and am having problems with my plug wires. These heads happen to have the angled plug design, and a spark plug on each side of the block goes directly into my headers. I still have the problem with "shorty" Accel spark plugs. I think my problem is that my headers are Headman ceramic-coated headers that were designed for the Corvette application, which "hugs" the block a little more. Before I take a chance and spend a lot of money on some new ceramic headers, does anyone have these heads, and headers that will work? If you have a part #, that would be great.
Adam
Adam
Le Mans Master
Joined: Aug 2000
Posts: 6,362
Likes: 7
From: Brazos TX
Cruise-In IV Veteran
Cruise-In V Veteran
Re: Headers that will work (cheeksspi)
I don't have your exact combination but perhaps mine will help. I have World Products angle plug heads and they fit fine with my headers. While I'm not sure who made my headers they look identical to Walker DynoMax (and Thrush) headers for Corvettes. In dealing with other people with the DynoMax headers I can say that they have the same routing style and fitment as mine so they are at least close relatives of some kind.
Instructor
Joined: Apr 2002
Posts: 229
Likes: 3
From: Highland MI
Re: Headers that will work (cheeksspi)
I have Hooker headers on my motor with angle plug heads. They are 23 deg. Winston Cup heads that were produced by Brodix. I had a problem with one plug and ended up cutting and moving the tube.
