header - head matching question
Thread Starter
Advanced
Joined: Dec 2021
Posts: 63
Likes: 9
header - head matching question
I have Aluminum Patriot Heads and Patriot tight tuck headers - I bought both about 10 years ago. I have had a problem with head gaskets constantly. Now in my current project I have learned the cylinder heads have square ports and the headers have round ports and there is very little area for the head gaskets to seal on the header flanges -
I am assuming I need to match the header ports to the square ports on the head - problem is though, I can't seem to find any short tube headers that clearly say they are for square ports - can someone point me in the right direction?
Frustrated,
Michael
I am assuming I need to match the header ports to the square ports on the head - problem is though, I can't seem to find any short tube headers that clearly say they are for square ports - can someone point me in the right direction?
Frustrated,
Michael
Race Director
Joined: May 2006
Posts: 18,726
Likes: 2,579
Have you tried Patriot header gaskets or contacted them?
https://pertronixbrands.com/products...0-square-1-5in
https://pertronixbrands.com/products...0-square-1-5in
Thread Starter
Advanced
Joined: Dec 2021
Posts: 63
Likes: 9
