front bumper gap

Reply Subscribe

Thread Tools

Search this Thread

Dec 12, 2003 | 04:17 PM

Todbo

Thread Starter

Burning Brakes

Joined: May 2001

Posts: 988

Likes: 1

From: Dyersburg TN

front bumper gap

I got my bumper on and this gap doesn't look right , the metal pads are cinched up to the fiberglass , what am I doing wrong? :crazy:

Dec 12, 2003 | 04:39 PM

James

Burning Brakes

Joined: Nov 2000

Posts: 948

Likes: 0

From: Johnston Iowa

Re: front bumper gap (Todbo)

Take a look at the center support that goes down to the front cross member that the radiator sits on.
It should be able to be moved a little to allow you to move the bumper up and in. 4 bolts hold it in place.

[Modified by James, 3:39 PM 12/12/2003]

Dec 12, 2003 | 05:28 PM

Todbo

Thread Starter

Burning Brakes

Joined: May 2001

Posts: 988

Likes: 1

From: Dyersburg TN

Re: front bumper gap (James)

should the bumper bracket pass thru the fiberglass, my front cap is a replacment , ie. the front side marker are not even cut out - yet

Dec 12, 2003 | 05:35 PM

rponfick

Drifting

Joined: Nov 2002

Posts: 1,688

Likes: 201

From: Loveland, CO

Re: front bumper gap (Todbo)

Also, you can put spacers or washers under that center support bracket if it needs to be raised further. It appears from your picture that the bumper is low. I'm sure you noticed the holes in the front of the support are slotted up and down for further adjustment. The bumper can be a bitch to adjust.

Reply Subscribe