Question about new heads and intake prep.
Thread Starter
Safety Car
Joined: Oct 2000
Posts: 4,282
Likes: 172
From: Lake Wylie, South Carolina
Question about new heads and intake prep.
When I get my Edelbrock Performer RPM aluminum heads and RPM Air Gap intake should I do anything like port matching the intake runners to the heads or smoothing the intake throat?
Team Owner
Joined: Sep 2003
Posts: 88,393
Likes: 2
From: eville in
Re: Question about new heads and intake prep. (BlackRat)
should be OK, but check anyway.. make sure ports in the intake aren't bigger then the intake port in the head.. make sure everthing is clean :thumbs:
Thread Starter
Safety Car
Joined: Oct 2000
Posts: 4,282
Likes: 172
From: Lake Wylie, South Carolina
Re: Question about new heads and intake prep. (Fevre)
Thanks guys just wanted to check and see if anyone else did any modifying to a similar setup or just bolt it on. I realy don't like the idea of cutting on brand new stuff. :eek:
Thanks
Wade
Thanks
Wade
Senior Member since 1492
Joined: Aug 2000
Posts: 87,936
Likes: 156
From: Just because I'm paranoid doesn't mean people aren't out to get me...
St. Jude Donor '09
Re: Question about new heads and intake prep. (BlackRat)
Thread Starter
Safety Car
Joined: Oct 2000
Posts: 4,282
Likes: 172
From: Lake Wylie, South Carolina
Re: Question about new heads and intake prep. (Jughead)
Jughead you are the man! :thumbs: Nice having someone doing the same project but is ahead of me in his progress. :D
Thanks
Wade
Thanks
Wade
