brake problem
Thread Starter
Instructor
Joined: May 2003
Posts: 108
Likes: 0
From: Pittsburgh Pa
brake problem
finally got a nice day to take the Vette out. Had to bring it back right away cause the "brake" light was staying on and the pedal went all the way to the floor. Seems like the brakes will pump up when not running but with the engine running I have nothing. I checked the fluid and it was low so I added some but that didn't do any good. Could it be a bad booster ? Would that make the brake light stay on? Gonna look at the simple things first but looking for any suggestions.banghead:
Thanks :
Thanks :
Instructor
Joined: Nov 2002
Posts: 157
Likes: 0
From: Greenbush WI
Re: brake problem (78 Vette)
:iagree:
If you can't find a leak anywhere then the master is leaking internally, that is, the pistons aren't pushing any fluid out to the calipers. Usually caused by the the bore being corroded up.
Don't even rebuildint it, just get a new one. If you are an original parts freak I believe SS Brakes will sleeve your original master. BUT - time and $$ and it is FINALLY summer for crysakes!
[Modified by geezer, 4:31 PM 3/28/2004]
If you can't find a leak anywhere then the master is leaking internally, that is, the pistons aren't pushing any fluid out to the calipers. Usually caused by the the bore being corroded up.
Don't even rebuildint it, just get a new one. If you are an original parts freak I believe SS Brakes will sleeve your original master. BUT - time and $$ and it is FINALLY summer for crysakes!
[Modified by geezer, 4:31 PM 3/28/2004]
Thread Starter
Instructor
Joined: May 2003
Posts: 108
Likes: 0
From: Pittsburgh Pa
Re: brake problem (geezer)
Thanks for the responses. Got a chance to look under the car with a light. Definitely something leaking on the driver's side front. Probably explains why it was pulling when I put on the brakes the last time I had it out in the fall.Guess I know what my next "project" will be this week. Aren't old car fun !! Thanks again ! :cheers:
Safety Car
Joined: Jun 2002
Posts: 4,757
Likes: 2,508
From: Buckeye, AZ
St. Jude Donor '12-'13
Re: brake problem (perk77)
The master may not leak, but you may be getting blow by around one of the "O" rings in the master cylinder. I had an issue I dogged for a season, where the brakes were good and hard and then you would get a soft pedal; immediately hit the brakes again and the were hard. I wanted to keep the oringal numbers, so I rebuilt the master. It took an hour to remove; rebuild; bench bleed, and back in the car. Another hour to bleed the system.
Safety Car
Joined: Jun 2002
Posts: 4,757
Likes: 2,508
From: Buckeye, AZ
St. Jude Donor '12-'13
Re: brake problem (perk77)
One more note.....I littel trick I found in the Chevy manual. Once the brake light comes on it may staty on indefintely. Once you correct the problem, you will need to push down on the pedal hard until you will feel a little kind of bump. the light will reset itself at that point.
Corvette Stories
The Best of Corvette for Corvette Enthusiasts
Top 10 Most Expensive Corvettes Ever Sold on Bring A Trailer
Brett Foote
10 Things Every Corvette Owner Needs (2026 Edition)
Michael S. Palmer
8 Most "Only Corvette Owners Understand" Quirks and Problems
Pouria Savadkouei
10 Reasons the C6 Z06 is Still A Performance Benchmark After 20 Years
Joe Kucinski
How Much Horsepower Every Corvette Engine "LOST" in 1972
Joe Kucinski
Top 10 DOs and DON'Ts for Protecting Your Convertible Top!
Michael S. Palmer
Top 10 Most Explosive Corvettes Ever Made: Power-to-Weight Ratio Ranked!
Joe Kucinski
150 hp to 1,250 hp: Every Corvette Generation Compared by the Specs That Matter
Joe Kucinski
8 Coolest Corvette Pace Cars (and Replicas) of All Time
Verdad Gallardo
Thread Starter
Instructor
Joined: May 2003
Posts: 108
Likes: 0
From: Pittsburgh Pa
Re: brake problem (gliot1)
glioti1 thanks for the heads up on the light. Found a badly leaking piston on the caliper. I'm going to replace the caliper. I was think of replacing it with a unit from NAPA. Has anyone had any good or bad experience with these??
Thanks
Thanks