Steering box
Thread Starter
Pro
Joined: Jan 2004
Posts: 535
Likes: 1
From: Darwin, Australia NT
Steering box
I'm pulling off the sump again from my GenV in a PS 70 coupe. I'ts depressing looking at all the linkage I have to remove, when I notice grease appears to be coming out of the bottom of the steering box. So I figure I might as well kill two birds with one stone and remove pitman arm and linkage together.
How hard is it to remove pitman arm from the box. Manual says I need a puller but my three jaw puller wont fit. Headers dont help either. Has anyone else fixed this seal with box in car?
How hard is it to remove pitman arm from the box. Manual says I need a puller but my three jaw puller wont fit. Headers dont help either. Has anyone else fixed this seal with box in car?
Safety Car
Joined: Jul 2002
Posts: 4,269
Likes: 3
From: St. Charles IL
Cruise-In 5-6-7-8-9-11-12 Veteran
A CI-6 Car Show Winner
Pittman arms can be tough, you will need a puller. There is no need to remove all that stuff unless you really want to. Normally you can un-bolt the idler bracket and the suspension will drop far enough to remove the oil pan.
Advanced
Joined: May 2003
Posts: 72
Likes: 5
From: Wilmington DE
This is not as much work as it may seem. Go to Pep Boys and buy a Pitman arm puller for about $20. Pop the Pitman arm, disconnect the idler arm bracket from the frame, disconnect the tie rods at the steering knuckles, disconnect the power steering ram and the hoses and the complete steering linkage will drop out in one piece. Shouldn't take more than a half hour to remove it all.
Thread Starter
Pro
Joined: Jan 2004
Posts: 535
Likes: 1
From: Darwin, Australia NT
Pitman arm puller
Originally Posted by henderjl
This is not as much work as it may seem. Go to Pep Boys and buy a Pitman arm puller for about $20. Pop the Pitman arm, disconnect the idler arm bracket from the frame, disconnect the tie rods at the steering knuckles, disconnect the power steering ram and the hoses and the complete steering linkage will drop out in one piece. Shouldn't take more than a half hour to remove it all.
Le Mans Master
Joined: Aug 2000
Posts: 6,362
Likes: 7
From: Brazos TX
Cruise-In IV Veteran
Cruise-In V Veteran
Burning Brakes
Joined: Oct 2004
Posts: 986
Likes: 23
From: Florence SC
If grease is leaking from your steering gear box, you might need to refurbish the entire box. There is a bushing at the bottom that wears out and allows the shaft that the pitman arm attaches too to wobble about, when this happens there is no seal made (that I'm aware of) that will stop the leak. 
Corvette Stories
The Best of Corvette for Corvette Enthusiasts
Top 10 Most Expensive Corvettes Ever Sold on Bring A Trailer
Brett Foote
10 Things Every Corvette Owner Needs (2026 Edition)
Michael S. Palmer
8 Most "Only Corvette Owners Understand" Quirks and Problems
Pouria Savadkouei
10 Reasons the C6 Z06 is Still A Performance Benchmark After 20 Years
Joe Kucinski
How Much Horsepower Every Corvette Engine "LOST" in 1972
Joe Kucinski
Top 10 DOs and DON'Ts for Protecting Your Convertible Top!
Michael S. Palmer
Top 10 Most Explosive Corvettes Ever Made: Power-to-Weight Ratio Ranked!
Joe Kucinski
150 hp to 1,250 hp: Every Corvette Generation Compared by the Specs That Matter
Joe Kucinski
