Replacing Starter on 89 conv.
08-07-2005, 04:45 PM
#1
Melting Slicks
Thread Starter
Member Since: Oct 2004
Location: Leeds Alabama
Posts: 2,283
Likes: 0
Received 0 Likes
on
0 Posts
Replacing Starter on 89 conv.
Are there any pitfalls or headaches that I need to plan for when replacing the starter (is it shimmed etc). Any tips would be appreciated - 89 convertible. Also where is the solenoid located (on the starter?)
08-07-2005, 04:53 PM
#2
Team Owner
Member Since: Oct 2004
Location: altered state
Posts: 81,242
Received 3,043 Likes
on
2,602 Posts
St. Jude Donor '05
Solenoid-Yes. Make sure and disconnect battery; the starter is heavy! If you have an auto it will probably drop on the trans lines (give your armS a break. You can then bend the lines out of the way and "twist it through. Good luck
08-07-2005, 06:23 PM
#4
Burning Brakes
I replaced the starter on my 86 (several times). On jacks, but it was not fun. It was incredibly tight and the starter just came out. If you like 3D puzzles...
08-07-2005, 07:35 PM
#5
Burning Brakes
Member Since: Jan 2005
Location: The land of 10,000 lakes ,Minnesota 89 coupe 6speed with 383 and 89 roadster 6speed bonestock with XXX low miles
Posts: 804
Likes: 0
Received 1 Like
on
1 Post
If you have headers on your 89 you may need to loosen or remove the passenger side header to remove starter I have to on my 89!
08-08-2005, 12:38 AM
#7
Pro
Member Since: Oct 2003
Location: Hesperia California
Posts: 550
Likes: 0
Received 0 Likes
on
0 Posts
Originally Posted by corvette1989bham
Thanks, does the car have to be on a lift , or is it enough room to just jack it up with a floor jack?
Jack stands please!
