Air lid mod
Safety Car
Joined: May 2003
Posts: 4,283
Likes: 0
From: Houston Texas
Worth it? Probably not much. But, you modify the top air filter lid that holds down the air filter. I drilled holes in each of the four corners then used a hack saw to cut in a staight line between the holes leaving just the out side of the lid to hold down the filter. This leaves the air filter exposed that was once covered by the louvered lid.
Race Director
Joined: Jun 2004
Posts: 13,958
Likes: 707
From: WI
You could try the d48mclain stacked up filters:
http://forums.corvetteforum.com/show...ht=stacked+lid
http://forums.corvetteforum.com/show...ht=stacked+lid
