Front Spoiler Question
Thread Starter
Drifting
Joined: Sep 2007
Posts: 1,396
Likes: 380
From: Cincinnati Ohio
Front Spoiler Question
Has any one purchased this front spoiler from Mid-America?? I am wondering about fitment and the quality of the part....I am looking at part # 600-952
http://www.mamotorworks.com/corvette?frame=1.463
Thanks in advance
http://www.mamotorworks.com/corvette?frame=1.463
Thanks in advance
Pro
Joined: May 2007
Posts: 638
Likes: 1
From: Robesonia Pa
I bought the 601-105 for my 1988. It was taller than the one I took off which I assume was factory. The fitment is not perfect I can see in some areas the seam is not tight to the bumper-hard to see unless you are looking for it. I had to buy longer bolts as the ones I removed were too short. While not bad the seam that fits to the bumper above the mount was uneven in height on one side by maybe 1/16 " when rounding the bumper. Not noticiable after install. All in all I would buy again but I think I would inquire if the bolt kit had longer bolts in it
