What did you do to your C4 today?
The following users liked this post:
LTPower95 (04-12-2021)
#83
Installed a new master cylinder flushed brake fluid and installed my 91' ZR1 saw-blades with new MT Sport Comps 315/35/17 in the rear and 275/40/17 in front. Found the right front tie rod boot ripped, going to replace next week.
The following users liked this post:
Bondo Lane (05-11-2022)
#85
Went out for a short drive (30 minutes). Realized I was low on fuel and stopped for 5 gallons (since premium was way overpriced on the highway). That five gallons took me from showing nearly empty to showing 5/8 full. So now I'm thinking through my fuel instrumentation
#90
Team Owner
Member Since: Dec 2000
Location: SE NY
Posts: 90,675
Likes: 0
Received 300 Likes
on
274 Posts
Cruise-In II Veteran
My RF headlight had hung up and today I finally got around to pulling the assembly and inspecting it to isolate the problem.
Much to my surprise I found the delrin bushings to be in great shape. After much pondering and more careful inspection finally I discovered a split in the side of the nylon gear.
Only problem now is that all the shops I've tried that stock the nylon unit are out of inventory till at least Mon...
Much to my surprise I found the delrin bushings to be in great shape. After much pondering and more careful inspection finally I discovered a split in the side of the nylon gear.
Only problem now is that all the shops I've tried that stock the nylon unit are out of inventory till at least Mon...
#95
Team Owner
Member Since: Sep 2003
Location: Freedom is never more than one generation away from extinction.
Posts: 20,161
Received 640 Likes
on
444 Posts
St. Jude '03-'04-'05-'06-'07-'08-'09-'10-'11-'12-'13-'14-'15-'16-'17-'18-‘19-'20-'21-'22-'23-'24
I'm hopin you guys post a ***t load of pics here.
#97
Intermediate
I called T.C.I. for about the tenth time to try to get them to send my transmission control unit back. I purchased the unit brand new this year and made it about 6 miles before it went bad. A month later I am still waiting. Sorry for the negative post I am just venting..............Jim S.
#98
3rd Gear
Member Since: May 2014
Location: plainfield illinois
Posts: 3
Likes: 0
Received 0 Likes
on
0 Posts
#99
Melting Slicks
#100
Safety Car
Yeah...they might as well be made of unobtanium...when you CAN find them they are asking platinum prices for them.
Wish someone would reproduce them...CCW? Are you listening?