Panel Replacement
Thread Starter
Heel & Toe
Joined: Jun 2015
Posts: 24
Likes: 0
Panel Replacement
Hi, I am replacing the rear surround panel on a 1990 convertible There is a metal reinforcement up over the wheel well that goes down the lock pillar on the replacement panel. The metal is rusted in a small area , surface only over the wheel well area what is the best way to take care of this so it will bond to the body and not rust again. IE what can I seal it with so it will properly bond and not come apart or rust later.
Thanks
Charles
Thanks
Charles
Safety Car
Joined: Aug 2002
Posts: 3,842
Likes: 230
From: SANTA CRUZ CA
Safety Car
Joined: Jan 2014
Posts: 4,017
Likes: 492
From: Poughkeepsie New York
Likely you will need bare metal for adhesion. I would call the adhesive company to see what they recommend. You would get better results asking in the paint section of the forum.
