1994 Door panels

Reply Subscribe

Thread Tools

Search this Thread

Oct 16, 2015 | 12:20 AM

CFore

Thread Starter

5th Gear

Joined: Dec 2014

Posts: 5

Likes: 0

1994 Door panels

On my 94 corvette my door pannels seem loose. They have a gap, I can push them to where there is no gap but then they go back. Can I tighten them? If so how? Or do I just need new panels? Any help would be greatly appreciated. Thank you.

Oct 16, 2015 | 07:29 AM

davewhtt

Pro

Joined: Oct 2012

Posts: 648

Likes: 6

From: weems va

Quote:

Originally Posted by CFore

The gap you are talking about is at the top? If so and all the screws are in then you will need to remove panel and look at the back plastic ribs for cracks. You may want to search on here some before that. Alot of information on this repair. Dave

Oct 16, 2015 | 07:49 AM

antfarmer2

Race Director

Joined: Mar 2015

Posts: 15,926

Likes: 579

Quote:

Originally Posted by CFore

on my 94 I took the door panels off. then drilled two small holes on a slight angle just under the inside window sweep front and back on each door, then put in two screws about two inches long so they would hook over the door frame. they are completly hidden by the thin lip on the window sweep. It works great and has been years.

Last edited by antfarmer2; Oct 16, 2015 at 07:51 AM.

Oct 16, 2015 | 01:58 PM

CFore

Thread Starter

5th Gear

Joined: Dec 2014

Posts: 5

Likes: 0

The gap is actually on the side. The top looks good.

Oct 16, 2015 | 03:13 PM

antfarmer2

Race Director

Joined: Mar 2015

Posts: 15,926

Likes: 579

Quote:

Originally Posted by CFore

The gap is actually on the side. The top looks good.

it would help with that too some get screw that come with a beveled washer that looks factory and put in the door pad to the frame most home stores have them.

Reply Subscribe

Reply Share

First
Prev
1 / 1
Next
Last

Forum Jump