FS: Melrose headers and TD
#1
Drifting
Thread Starter
Melrose headers and TD
Had this paired with a true dual setup. Sounded great but I wanted it to look better mainly so upgraded. Have 2 magnaflow bullet cats ($150 each new) also.
$100 or $200 with cats. Will not ship due to size but will meet in Texas.
I have the other piece that slips onto the right tube to fit to melrose LT headers. Not sure what else it will fit.
$100 or $200 with cats. Will not ship due to size but will meet in Texas.
I have the other piece that slips onto the right tube to fit to melrose LT headers. Not sure what else it will fit.
Last edited by 383tpimachine; 05-14-2017 at 09:34 PM.
The following users liked this post:
383tpimachine (04-07-2017)
#3
Headers
383tpimachine Are you in Austin, Tx. If so I'm in Round Rock and would like to headers if still availible. TIA
#6
Advanced
Member Since: Sep 2009
Location: Milwaukee WI
Posts: 77
Likes: 0
Received 0 Likes
on
0 Posts
How crazy will shipping be to send the headers to a business at 53045? Can you get me a measurement from the mounting flange to the outside of the collector? Basically a width measurement. I built a custom front half of the frame for my 51 truck to fit c4 suspension so I want to make sure the headers will clear where the new frame meets the old frame.
#7
Drifting
Thread Starter
How crazy will shipping be to send the headers to a business at 53045? Can you get me a measurement from the mounting flange to the outside of the collector? Basically a width measurement. I built a custom front half of the frame for my 51 truck to fit c4 suspension so I want to make sure the headers will clear where the new frame meets the old frame.
Not sure what measurement you want
#8
Advanced
Member Since: Sep 2009
Location: Milwaukee WI
Posts: 77
Likes: 0
Received 0 Likes
on
0 Posts
If the headers were still mounted on the car I'm looking for a measurement from the cylinder head straight out towards the side of the car to the outer most spot on the headers. Preferably measured near the collecter. I want to make sure they will fit between my frame rails.