WTB: C4 Z51 Parts - Springs and Roll Bars.
#1
Intermediate
Thread Starter
C4 Z51 Parts - Springs and Roll Bars.
Looking for z51 spring and sway bars I have a 1990 C4 Would be willing to Trade parts for Non-Z51 Sway bars & Springs.
#2
Burning Brakes
Member Since: Oct 2005
Location: Shelbyville IN
Posts: 849
Likes: 0
Received 0 Likes
on
0 Posts
If you're still looking, my files show an FHB front spring and an NYU rear as Z51 pieces. Will check later today, but I think I have both. $100 for the FHB, $150 for the NYU. Plus shipping.
#4
Race Director
I have some front and rear roll bars that are off of a couple 90-91 ZR-1s I parted out.
I'm not sure if they are the same as a Z51 I can't remember.
but I can get them out measure them and let you know what size they are.
I'm not sure if they are the same as a Z51 I can't remember.
but I can get them out measure them and let you know what size they are.
#5
....
Last edited by Fauxari08; 02-22-2018 at 10:46 PM.
#6
Race Director
Well i measured the 2 sets of sway bars I have in my stash both taken off of ZR-1s I have parted. As well as the ones on my 90 ZR-1.
All 3 are 26mm front and 24mm rear. They feel pretty solid to me and not hollow at all.
#7
fronts are tubular. look it up. as for 24 mm never heard of that being used on a ZR! . but hey you measure it. good luck hopefully he buys them.
#8
this is the specs so we are on same page i'm not into he said she said.
https://www.corvetteactioncenter.com...usp_chart.html
i have parted 3 Z's and over 40 vettes over years. own a an extremely RARE c4 and have dealt with vette owners from old turds to concourse level. when i put my 2 cents in its passion not ignorance, nothing like hands on experience and selling thousands of parts. this chart is to show that i am correct as i have researched c4 vettes above and beyond it's a living not a hobby in my eyes.
Last edited by Fauxari08; 02-23-2018 at 10:07 PM.
#9
Race Director
I love to know how I'm measuring these rear sway bars incorrectly.
Got a part number handy ? As these rears have a part number.
The fronts have X220 stamped in them.
And I have only ever parted out ZR-1s 2 90s and a 91. I highly doubt all three were swapped so maybe I'm measuring them wrong.
Because I'd love it if they were sought-after 26 mm I'd like to sell em.
Got a part number handy ? As these rears have a part number.
The fronts have X220 stamped in them.
And I have only ever parted out ZR-1s 2 90s and a 91. I highly doubt all three were swapped so maybe I'm measuring them wrong.
Because I'd love it if they were sought-after 26 mm I'd like to sell em.
Last edited by phrogs; 02-25-2018 at 03:48 AM.