FS: 1986 Dana 44 Complete rear caliper to caliper 3.07 Limited slip
#1
Drifting
Thread Starter
Member Since: Feb 2016
Location: Simi Valley CA
Posts: 1,312
Likes: 0
Received 313 Likes
on
261 Posts
1986 Dana 44 Complete rear caliper to caliper 3.07 Limited slip
I have a stock Dana 44 from a 86 4+3 coupe. The dash was gone so unsure of the miles. The car had been sitting. I would recommend replacing the seals and going through it. I have shipped Dana 44s through Fastenal using their store to store service. It is around 200.00. You pay freight when you pick it up. I am asking 1100.00. I am located in Santa Clarita, CA.
#3
Safety Car
Do you have the c-beam and drive shaft to go along with it ? that would make it more attractive to a C4 owner.
I just purchased one of these (3.07 ratio) and your price is fair for market value. A 3.07 is a good compromise for an automatic car. Good performance and doesn't spin the engine up so high while on the highway.
With the drive shaft and c-beam a C4 owner could get it all rebuilt, polished, etc and simply swap it in.
I just purchased one of these (3.07 ratio) and your price is fair for market value. A 3.07 is a good compromise for an automatic car. Good performance and doesn't spin the engine up so high while on the highway.
With the drive shaft and c-beam a C4 owner could get it all rebuilt, polished, etc and simply swap it in.
Last edited by drcook; 08-16-2018 at 10:51 PM.