FS: 91-96 Euro Tail light setup with complete rear harness - used
#1
Melting Slicks
Thread Starter
91-96 Euro Tail light setup with complete rear harness - used
edit 7/28 - they are sold. Thanks guys.
Hi all,
I have a euro tail light setup off my car that is being parted out. I pulled the ENTIRE REAR LIGHT HARNESS and left everything intact. This is the harness that controls the tailights, the side marker lights, plate light and brake lights. Theoretically, if you wanted to install this, you would take off your bumper cover, take off the right trunk trim panel and sun shade, and then you should have access to plug this harness in after removing yours..
These lights have been discontinued/not available anywhere for years. The last part available were the lenses and then you still had to come up with a harness and find the instructions.
Once again, this is a perfectly working kit that was working up till the day I started parting the car. I'll even include all the bulbs if I can figure out a way to pack them so they won't break.
$750 + shipping + paypal fees (if using paypal).. This is by far the most asked about part of my car so I am firm on the price as someone will buy it at this price. This will be the one and only time you'll likely see a kit with wiring harness on here.
Hi all,
I have a euro tail light setup off my car that is being parted out. I pulled the ENTIRE REAR LIGHT HARNESS and left everything intact. This is the harness that controls the tailights, the side marker lights, plate light and brake lights. Theoretically, if you wanted to install this, you would take off your bumper cover, take off the right trunk trim panel and sun shade, and then you should have access to plug this harness in after removing yours..
These lights have been discontinued/not available anywhere for years. The last part available were the lenses and then you still had to come up with a harness and find the instructions.
Once again, this is a perfectly working kit that was working up till the day I started parting the car. I'll even include all the bulbs if I can figure out a way to pack them so they won't break.
$750 + shipping + paypal fees (if using paypal).. This is by far the most asked about part of my car so I am firm on the price as someone will buy it at this price. This will be the one and only time you'll likely see a kit with wiring harness on here.
Last edited by qwiketz; 07-29-2019 at 01:08 AM.
#6
Burning Brakes
#8
Melting Slicks
Thread Starter
#9
The wiring is easy. The lenses are the valuable pieces.
#11
Le Mans Master
Actually the wiring mods are pretty straight forward. Takes a bit of work. I don’t enjoy working on interiors but basically u will be separating the signal lamp operation from the taillamps. So new signal lamp sockets wired in. Then u need to get a feed for the brake light signal, which I took off the CHMSL rather than clipping wires at the brake switch. I did wiring mods so as to minimize any cutting to existing harness. There were 2 wires I clipped and provided connectors if someone ever wanted to restore taillamps to original.
#12
Melting Slicks
Thread Starter
very cool to hear that it's possible as a diy. For those of us that aren't as great with the electrical, this is a good option. Without the instructions available, I would probably make a mess of this thing if I were to attempt.
#13
Le Mans Master
More time consuming than difficult. No need for a EE degree. However, now u have 8 bulbs back there. And that’s where the LEDs come in. When I had turn signal on at a stop, the voltmeter would swing away. Now it barely moves.
#20
Melting Slicks
Thread Starter