frisbee
But you will need a breaker bar to hold the pulleys in place while you do it. (I'm not sure if you'll need to use it if you use an air gun)
Safety Car
Joined: Jul 2004
Posts: 3,845
Likes: 30
....very easy to do as i did it on my 88. you can use a socket/ratchet. i then took up the space that the "frizbee" took up with a few flat washers, a lock washer, and a dab of loc-tite (if i remember correctly).
i'll check it later and if different, will edit this post!
i'll check it later and if different, will edit this post!
Team Owner
Joined: May 2006
Posts: 21,473
Likes: 356
From: Palmdale, Ca----- 2009 Cyber Gray 4LT A6 F55 452 RWHP 422 RWTQ- RIP 1998 C5 734 RWHP & 585 RWTQ-----
1/2 hour job drinking a beer and occasionaly scratching your butt! All I needed to do was remove the four bolts and wala! remove the frisbee and reinstall the bolts to the water pump pulley, tighten and done! The belt held everything in check no need for to many tools for this mod!
Thanks,Matt
Thanks,Matt
