LT1 Cam Question
Thread Starter
Racer
Joined: Mar 2002
Posts: 498
Likes: 21
From: Maine
LT1 Cam Question
I'm looking to hear from people who have/had experience with the following 3 cams:
LPE - 74211 211/219 .530/.560 112 LSA with 1.6 rocker
Comp Cams XFI - 07-466-8 218/224 .570/.565 113 LSA with 1.6 rocker
Crane 104227 210/224 .511/.553 112 LSA with 1.6 rocker
I'm looking for a little more lower end torque and more HP and Torque under the curve if possible. I'm not interested in cams bigger than the ones listed, as the Hot Cam I have now has all the lope as I would like.
(sort of a compare and contrast to the Hot Cam that I currently have installed)
LPE - 74211 211/219 .530/.560 112 LSA with 1.6 rocker
Comp Cams XFI - 07-466-8 218/224 .570/.565 113 LSA with 1.6 rocker
Crane 104227 210/224 .511/.553 112 LSA with 1.6 rocker
I'm looking for a little more lower end torque and more HP and Torque under the curve if possible. I'm not interested in cams bigger than the ones listed, as the Hot Cam I have now has all the lope as I would like.
(sort of a compare and contrast to the Hot Cam that I currently have installed)
Last edited by 93Blackrose; Jan 7, 2007 at 07:34 PM.
Burning Brakes
Joined: Nov 2004
Posts: 800
Likes: 3
From: Port Orange FL
Well I have an LPE that as I remember is 213/219 and around 500 lift. It idles and drives just like stock. And it pulls hard up to around 6200. I made 316 Hp with it. The low end is about the same as it was stock. No loss, but certainly no improvement.
Roy
Roy
