Oxygen sensor harness connector replacement
Thread Starter
Advanced
Joined: Jan 2006
Posts: 77
Likes: 1
Oxygen sensor harness connector replacement
Does anyone know a part number for a replacement connector/pigtail that goes to the oxygen sensor? This is the connector that is coming off the main harness; it is damaged and it needs to be replaced on my 1986 coupe. It is a single wire connection.
Thanks!
Thanks!
Burning Brakes
Joined: Nov 2005
Posts: 908
Likes: 1
From: Colorado Springs Colorado
I can't remember the part number, but it's a standard weather-pak single terminal connector that NAPA carries, I've bought tme there before. If you are careful, you can crush the connector shell with pliers and save the guts to just push into the new shell. If you can't find one local, PM me and I'll send you one or two.
Team Owner
Joined: Oct 2000
Posts: 96,443
Likes: 9
From: Fort Knox, KY
Cruise-In IV Veteran
Cruise-In VI Veteran
Cruise-In VII Veteran
Cruise-In VIII Veteran
Yup. NAPA carries them. I broke one of my pigtail connectors last summer when I was replacing one of my 02 sensors, too.
Thread Starter
Advanced
Joined: Jan 2006
Posts: 77
Likes: 1
I just replaced my pigtail with one from NAPA. They are by far a better parts store than AutoZone, Advance, O'Reilly, etc.
Anyways, for those looking for a part number on this connector, it is ECHOSC100 from NAPA.
Hope this helps someone else in the future!
Anyways, for those looking for a part number on this connector, it is ECHOSC100 from NAPA.
Hope this helps someone else in the future!
