measurement needed on runners please
Thread Starter
Advanced
Joined: Jul 2006
Posts: 53
Likes: 0
From: las vegas nv
measurement needed on runners please
if someone has a set of stock intake runners from a 87ish l98 i would appreciate a measurement of the ID of one of the holes.
i bought a set of "supposedly" tpis runners and i can find no markings to show they are anything but stock.
i measure 1.5 inches ID on each hole.
thanx in advance!
Bret from blistering hot las vegas.
i bought a set of "supposedly" tpis runners and i can find no markings to show they are anything but stock.
i measure 1.5 inches ID on each hole.
thanx in advance!
Bret from blistering hot las vegas.
Drifting
Joined: Jun 2001
Posts: 1,704
Likes: 459
From: Mass Mass
The stock runners are about 1.5 inches, the AS&M (TPIS) runners are about 1.65 inches (both on the inside).
This guy has some good pict's of both on his site.
http://www.eecis.udel.edu/~davis/z28/buildup/runners/
This guy has some good pict's of both on his site.
http://www.eecis.udel.edu/~davis/z28/buildup/runners/
