TPIS Headers and exhaust gasket mismatch
Thread Starter
Melting Slicks
Joined: Aug 2000
Posts: 2,381
Likes: 42
From: Murrysville PA
TPIS Headers and exhaust gasket mismatch
I remember reading a post a while ago where someone claimed that there was a mismatch between the header or the header gasket on TPIS headers and the L98 and/or AFR heads. I did search after search and cannot find anything. I'm hoping that the person that discovered it reads this and responds or that maybe someone else knows about it.
TIA
TIA
Burning Brakes
Joined: Nov 2000
Posts: 1,012
Likes: 1
From: Bowie MD
Re: TPIS Headers and exhaust gasket mismatch (89vette)
I have the TPIS Headers and L98 (or ZZ4) Alum D port heads. There we no mismatch on the gaskets there. Maybe it was those aftermarket Heads with large square Holes???
Thread Starter
Melting Slicks
Joined: Aug 2000
Posts: 2,381
Likes: 42
From: Murrysville PA
Re: TPIS Headers and exhaust gasket mismatch (tntcorvette)
I am using MSD Super Conductor wires. No I did not replace my springs and I'm not going to either. There is no reason to go into the motor even if my HP is a little low. Mash the gas and you would understand.
I'll just look at the little things over the winter. Might upgrade to a MSD Digital 6 also.
Jason
I'll just look at the little things over the winter. Might upgrade to a MSD Digital 6 also.
Jason
