hub assembly question
#1
Advanced
Thread Starter
Member Since: Feb 2007
Location: belmont maine
Posts: 95
Likes: 0
Received 0 Likes
on
0 Posts
hub assembly question
Hi, my Service ASR/ABS light has been going on. Mechanic diagnosed wheel speed sensor. Says I need new hub assembly. Just checking to see if this is so. Thanks, Larry
#2
Le Mans Master
Member Since: Sep 2003
Location: Littleton CO
Posts: 5,874
Likes: 0
Received 0 Likes
on
0 Posts
It's possible. The front bearing/hub assemblies have the sensor built in. I'd make sure that he tried cleaning the harness connectors, etc. or somehow verified that the sensor was bad, since the parts are pretty expensive.
For the rear, speed sensors have nothing to do with the hub assemblies.
For the rear, speed sensors have nothing to do with the hub assemblies.
#3
Instructor
Member Since: Feb 2007
Location: Wellington Fl
Posts: 121
Likes: 0
Received 0 Likes
on
0 Posts
Hi,
He may be right, I had the same problem, used the FSM to troubleshoot and even went so far as to swap the front hubs to verify myself. Installed new fromt hub assy and problem went away.
But first like was suggested check all connects and clean before you do anything, especially the connection on the hub assy itself.
Good luck
He may be right, I had the same problem, used the FSM to troubleshoot and even went so far as to swap the front hubs to verify myself. Installed new fromt hub assy and problem went away.
But first like was suggested check all connects and clean before you do anything, especially the connection on the hub assy itself.
Good luck
#4
Drifting
I'm not sure about this, but I seem to recall another post describing how the 'teeth' that the sensor reads can be filled in with road debri causing inaccurate readings.
Anybody??
Anybody??