91 Tach Filter Identification
Thread Starter
Team Owner
Joined: Jul 2004
Posts: 28,343
Likes: 3,252
From: Hartford WI
91 Tach Filter Identification
I seem to have an issue with my tach. I am going to try the tach filer. Problem is I went with an HSR so I don't have the same setup. In any case, I found a couple of wires that go from my distributor. One is pink and the other is white. It goes to my remote coil. Well, that white from the coil leads to a rectangular box. One white going in, one white going out and a black. Sounds like a tach filter to me. However, it is rectangular and not round like others are saying. Is that it?
Le Mans Master
Joined: Feb 2005
Posts: 5,146
Likes: 3
From: The Motor City
on my 90 it has only one white in and out and it is round.
It will be hard to see w/out taking off the dist. cap. Look on the top bolt of the trans case to the bloclk at approx. the 1 oclock position.
It will be hard to see w/out taking off the dist. cap. Look on the top bolt of the trans case to the bloclk at approx. the 1 oclock position.
Le Mans Master
Joined: Feb 2005
Posts: 5,146
Likes: 3
From: The Motor City
intersting, always thought the 90 and 91 to be the same. In my FSM they don't even show the tach filter as such, however the white tach wire at the dist. was directly wired to the filter, then to the main harness.
Thread Starter
Team Owner
Joined: Jul 2004
Posts: 28,343
Likes: 3,252
From: Hartford WI
