Rocker upgrade
Thread Starter
Le Mans Master
Joined: Dec 2006
Posts: 5,139
Likes: 482
From: H-Town Texas
Rocker upgrade
I had posted once about upgrading to 1.7 rollers on my LT4. All of the responses (thank you) were positive in this direction, and I think I want to go ahead with it. So my question is this, where can I find them? The only 1.7 rollers I've found are for either LSx or big block heads. I believe my stock springs will handle the extra lift, at least I am told. But what about the stud mounts? I know that the LT4 uses a special stud specific to this engine, so how do I go about making this change in terms of aquiring the proper parts? Any help would much appreciated if even a simple lead to the right direction. Thanks guys
Large Impressive Member
Joined: Jul 2003
Posts: 65,811
Likes: 71
From: Good health is merely the slowest possible rate at which one can die
St. Jude Donor '04-'05-'06-'07
I believe Nathan Plemmons did this one time. He may have used Scorpions but I'm not sure. I'm relatively sure though that Jesel, Harland Sharp or some other high level producer of serious valve train components could help you out. 
I've considered this someday too, down the road.
I've considered this someday too, down the road.
Drifting
Joined: Oct 2005
Posts: 1,257
Likes: 4
From: North Carolina
I believe Nathan Plemmons did this one time. He may have used Scorpions but I'm not sure. I'm relatively sure though that Jesel, Harland Sharp or some other high level producer of serious valve train components could help you out. I've considered this someday too, down the road.
I've considered this someday too, down the road.DG
