Shes a roller again ......
Thread Starter
Melting Slicks
Joined: Jul 2003
Posts: 2,284
Likes: 4
From: Canton MI
Shes a roller again ......
Sup guys,
Just got done putting my whole front end after lowering it and installing new poly bushing and ball joints. Also my new wheels came in after being on backorder for 3 weeks the rear wheels are 12 inch wide with a M/T 315-60-15 . The motor is back in it and the trans should be back in it by the end of the week. All that is left is some minor work and paint and she’s ready for another racing season …
Just got done putting my whole front end after lowering it and installing new poly bushing and ball joints. Also my new wheels came in after being on backorder for 3 weeks the rear wheels are 12 inch wide with a M/T 315-60-15 . The motor is back in it and the trans should be back in it by the end of the week. All that is left is some minor work and paint and she’s ready for another racing season …
Last edited by red L98; Mar 21, 2008 at 02:28 AM.
Thread Starter
Melting Slicks
Joined: Jul 2003
Posts: 2,284
Likes: 4
From: Canton MI
for all out there that don’t know much about my straight axle setup. It’s the same 12 bolt Jesse offers with same 4link rods, wishbone, 4 link brackets with full adjustability , no cross member, and same coil over setup Jesse offers, it’s a hybrid of jesses setup. With the way Jesse and I have it setup you can run a 30 inch tall tire tucked in real nice. For most guys to be able to fit that tall of a tire they need to mini tub and cut the frame rails or raise there car so high and have it sit like a 4x4 …. Thanks Jesse for all the help and super fast service
cant wait to pull some 1.2x 60 foots 
Thread Starter
Melting Slicks
Joined: Jul 2003
Posts: 2,284
Likes: 4
From: Canton MI
