There are no stupid questions...
Thread Starter
Instructor
Joined: May 2004
Posts: 187
Likes: 0
From: Fort Drum New York
There are no stupid questions...
But lots of inquisitive idiots..
So heres mine. I can account for all the connectors on makeing this LT1 Wiring harness stand alone....except this one. Any idea what this is or what it connects too? Im stumped.
The engine is a 1994 if that makes a difference.
Thanks again,
Bob
So heres mine. I can account for all the connectors on makeing this LT1 Wiring harness stand alone....except this one. Any idea what this is or what it connects too? Im stumped.
The engine is a 1994 if that makes a difference.
Thanks again,
Bob
Last edited by Iskenderian; Jul 11, 2008 at 10:48 PM.
Supporting Vendor
Joined: Mar 2008
Posts: 1,762
Likes: 14
From: Cumming Ga
But lots of inquisitive idiots..
So heres mine. I can account for all the connectors on makeing this LT1 Wiring harness stand alone....except this one. Any idea what this is or what it connects too? Im stumped.
The engine is a 1994 if that makes a difference.
Thanks again,
Bob
So heres mine. I can account for all the connectors on makeing this LT1 Wiring harness stand alone....except this one. Any idea what this is or what it connects too? Im stumped.
The engine is a 1994 if that makes a difference.
Thanks again,
Bob
http://www.lt1swap.com/wiringharness.htm
Safety Car
Joined: Oct 2007
Posts: 3,816
Likes: 0
From: :45 minutes from everywhere / E-I-E-I-O
I put my cash on interior, or chassis rear electrical harness; not engine, but maybe tranny.
FSM shows connector 'faces' - about 60 roughly, and the only 6-ways that are linear are for the 'radio receiver box' (not a weatherproof connector), a transmission position switch connector (not a w/p connector), and temperature door motor ((2 x 6,) not w/p).
It looks like an ignition switch harness connector...
FSM shows connector 'faces' - about 60 roughly, and the only 6-ways that are linear are for the 'radio receiver box' (not a weatherproof connector), a transmission position switch connector (not a w/p connector), and temperature door motor ((2 x 6,) not w/p).
It looks like an ignition switch harness connector...
