Nitrous engine build-up
Thread Starter
Drifting
Joined: Oct 2001
Posts: 1,351
Likes: 20
From: Back in San Diego Ca
Nitrous engine build-up
I am building an engine soon, in about 3 months or so, while I am at school. I am going to UTI, Universal Technical Institute. It's an auto tech school for those who don't know. Anyways, I am getting from the subject like I do sometimes. I will finish installing my Nitrous system tomorrow, and was wondering what internals I should use for the next engine. I will be building a 383 or maybe a little bit bigger. What should I use that is bullet proof an can handle well over a 200 shot?
[Modified by OrangeC4, 7:45 AM 2/21/2002]
[Modified by OrangeC4, 7:45 AM 2/21/2002]
Race Director
Joined: Oct 2000
Posts: 16,477
Likes: 1
From: Enter Post Count Here
Re: Nitrous engine build-up (OrangeC4)
http://www.scatcrankshafts.com/smblkchevyrotating.html
Forged. :yesnod:
[Modified by NoWorries, 12:54 AM 2/21/2002]
Forged. :yesnod:
[Modified by NoWorries, 12:54 AM 2/21/2002]
Thread Starter
Drifting
Joined: Oct 2001
Posts: 1,351
Likes: 20
From: Back in San Diego Ca
Re: Nitrous engine build-up (89 Paul in cal)
I am definitly using forged, but was looking for a specific brand that has worked well for others. There are tons out there and am trying to narrow it down a bit.
The cool thing about UTI, is that the school takes students to the drag strip to run their cars. When I was up there, I saw a lot of stangs that I would like a shot at.
The cool thing about UTI, is that the school takes students to the drag strip to run their cars. When I was up there, I saw a lot of stangs that I would like a shot at.
Race Director
Joined: Oct 2000
Posts: 16,477
Likes: 1
From: Enter Post Count Here
Re: Nitrous engine build-up (OrangeC4)
Jeese, my second reply and I'm only now getting to this:
EEEEEEEEEEEEEEEEEEekkkkkkkkkkkkk!
Anyways, TRW seems to be a favorite for pistons, otherwise, I dunno. :)
EEEEEEEEEEEEEEEEEEekkkkkkkkkkkkk!
Anyways, TRW seems to be a favorite for pistons, otherwise, I dunno. :)
Team Owner
Joined: Aug 2000
Posts: 32,844
Likes: 0
From: Looking California Feeling Minnesota
St. Jude Donor '03-'04-'05-'06-'07'-08
Re: Nitrous engine build-up (OrangeC4)
Pass me any info you get, and I'll do the same!!:yesnod: I'm building up a 383 4 bolt for nitrous right now in my 88. :cheers:
Advanced
Joined: Jan 2002
Posts: 80
Likes: 0
From: Clarksville Tn
Re: Nitrous engine build-up (jackyl)
I like Callies cranks and rods, as you can see in my sig. Just about every other crank on the market except callies is made by the same crank company, so they are all alike. JE pistons do really well on n20 as well. I built my motor for nitrous.
