Corvette Distributor .491 or .500
Thread Starter
Race Director
Joined: Oct 2000
Posts: 16,477
Likes: 1
From: Enter Post Count Here
Corvette Distributor .491 or .500
Car-1987, factory HEI distributor
I'm ordering a new Distributor gear(well, two), what size is the Corvette distributor shaft, 0.500 inches or 0.491 inches?
I seem to recall paying $43 the last time, and thats the .500 one. The car is a mile away and I'm not feeling up to going and measuring.
This is from Crane's website:
I should probably just go measure it. :smash:
Any help would be appreciated. Thanks. :)
I'm ordering a new Distributor gear(well, two), what size is the Corvette distributor shaft, 0.500 inches or 0.491 inches?
I seem to recall paying $43 the last time, and thats the .500 one. The car is a mile away and I'm not feeling up to going and measuring.
This is from Crane's website:
11990-1 .491" Electronic ignition with unitized coil/distributor
cap. Usually found in Corvettes.
cap. Usually found in Corvettes.
Any help would be appreciated. Thanks. :)
