fuel pump question
Thread Starter
Advanced
Joined: Jul 2011
Posts: 64
Likes: 0
fuel pump question
Well I went to start my 383 for the first time today and ran into a bit of a problem. I put a mechanical oil pressure gauge in. Well I wasnt thinking that the computer has to have that sender to let the fuel pump turn on. My question is, is there any way to by pass this? and/or put the pump to a switch instead?
Safety Car
Joined: Jan 2004
Posts: 3,556
Likes: 12
Need full story on your engine swap
What induction?
If you have done a carb conversion then you need to wire the relay to the Ign switch
so it gets power to run the pump
The computer runs the pump relay by itself without any input from the OP switch.
Op switch runs the pump direct passing the relay as a backup to the relay
What induction?
If you have done a carb conversion then you need to wire the relay to the Ign switch
so it gets power to run the pump
Op switch runs the pump direct passing the relay as a backup to the relay
Last edited by vetteoz; Feb 20, 2012 at 10:09 PM.
Safety Car
Joined: Jan 2004
Posts: 3,556
Likes: 12
