Help - Floppy High Beam Lever
Thread Starter
Burning Brakes
Joined: Feb 2013
Posts: 769
Likes: 95
From: Central Pennsylvania
Help - Floppy High Beam Lever
Ok, I was suffering from a floppy high beam lever on my '89. Everything else works. Dropped column, adjusted high beam switch, actuator rod brings up the high beams when actuated from below with pliers. Pull the steering wheel, etc, pulled the actuator as pictured. Found that a previous owner had broken the extended tab off ( looks like a shark fin ??). Next problem where do I find one of these ? 1989 base cpe with tilt/telescopic. This is the part that the multi-function lever slides into. I been using google, but I'm not even sure what this part is called. I'm not sure if JB Weld will put this back together.
Last edited by skyhawk50; Apr 14, 2014 at 06:51 PM.
