Recommendation on roller cam & lifters
#21
Team Owner
Member Since: Oct 2004
Location: altered state
Posts: 81,242
Received 3,043 Likes
on
2,602 Posts
St. Jude Donor '05
bjanski
small or stock specs i doubt youd notice the difference between a roller or flat tappet save your money
Last FT I installed only ran it long enough to time it ck for leaks just started driving it. Didnt let it idle long but lasted just fine. If they spin in their bores they oughta be Ok. I dont believe in all the special procedures never needed them back in the 70s or 80s. They fired em up and off the lot they went.
small or stock specs i doubt youd notice the difference between a roller or flat tappet save your money
Last FT I installed only ran it long enough to time it ck for leaks just started driving it. Didnt let it idle long but lasted just fine. If they spin in their bores they oughta be Ok. I dont believe in all the special procedures never needed them back in the 70s or 80s. They fired em up and off the lot they went.