1984 starter chatter
Thread Starter
Advanced
Joined: Mar 2017
Posts: 89
Likes: 3
From: Portland OR
I will be working through the flowchart now that I've confirmed that I didn't break the knock sensor/cable.
Not yet, though when I check their website it seems to be a mess. I select my car, search starter and of the ten starters that appear, four of them could not possibly work, while the one I was given says that it only "may fit" by vehicle.
When I search the first number you gave me, 1998400,
I find this: https://www.napaonline.com/en/search...rm-interchange
At the bottom of that page, I can see the P/N I got, NAE 76016.
Same place on the 84.I did find the set timing connector on the driver side, black/brown cable. I unplugged/plugged it and saw no difference (disconnected the battery inbetween).
My next steps are:
- Confirm CE 42
- Check set timing connector/wire.
- Work through correct flowchart, depending on the code I find.
Thanks for all the help guys, hopefully I/we can solve this soon
Thread Starter
Advanced
Joined: Mar 2017
Posts: 89
Likes: 3
From: Portland OR
Well I went to check the code tonight. I disconnected the battery for a few minutes before, just to make sure it wasn't a hold over. I also disconnected, checked the impedance and reconnected the set timing cable (before reconnecting the battery).
No codes.
I have no idea what I did to cause or to fix the code.
I fully expect it to come back as soon as all four tires are on the ground again, just because.
No codes.
I have no idea what I did to cause or to fix the code.
I fully expect it to come back as soon as all four tires are on the ground again, just because.
