Fuel gauge not reading
Thread Starter
Intermediate
Joined: Oct 2017
Posts: 41
Likes: 1
Fuel gauge not reading
Ok, so now my fuel gauge has decided not to go below full. Checked the resistance at the connection by the pump and it reads properly according to the manual. Any other ideas?
BTW, it's an 87 /manual trans
BTW, it's an 87 /manual trans
Last edited by vtdave577; Jul 13, 2018 at 06:41 PM.
Drifting
Joined: Jun 2013
Posts: 1,590
Likes: 60
From: ft myers FL/Munising MI
Burning Brakes
Joined: Jun 2007
Posts: 765
Likes: 49
From: West Palm Beach,Florida
[QUOTE=playsdixie;1597596230]you can pull out the sending unit and clean it, but I didn't have a lot of luck with the procedure...after several attempts, I just put a new one in.....old one wasn't stainless anyway...Racetronix has a nice kit with gasket, new bolts. etc....in case you haven't pulled it out lately....[/QUOTE
which sending unit did u buy?
[/QUOTEwhich sending unit did u buy?
Drifting
Joined: Jun 2013
Posts: 1,590
Likes: 60
From: ft myers FL/Munising MI
[QUOTE=rhandle;1597602303]
stainless unit from corvette central....been in 6years....pulled it recently, still just like new.....
you can pull out the sending unit and clean it, but I didn't have a lot of luck with the procedure...after several attempts, I just put a new one in.....old one wasn't stainless anyway...Racetronix has a nice kit with gasket, new bolts. etc....in case you haven't pulled it out lately....[/QUOTE
which sending unit did u buy?
[/QUOTEwhich sending unit did u buy?
