Code 15 ... how do you fix this one?
Thread Starter
Drifting
Joined: Oct 2001
Posts: 1,439
Likes: 4
From: Kewaskum Wisconsin
Code 15 ... how do you fix this one?
I have a code 15 that is constant. Coolant Sensor Circuit (Low).
I have checked all of my coolent fluid levels and they are fine. What is the remedy for this code?
Thanks for the help.
I have checked all of my coolent fluid levels and they are fine. What is the remedy for this code?
Thanks for the help.
Burning Brakes
Joined: Apr 2002
Posts: 755
Likes: 0
From: Patterson CA
Re: Code 15 ... how do you fix this one? (Hole-Shot)
Check wiring, connectors, thermostat. Monitor actual engine temperature.
If within limits, and wiring/connector is OK, change thermostat and/or sensor. :yesnod:
If within limits, and wiring/connector is OK, change thermostat and/or sensor. :yesnod:
Team Owner
Joined: Dec 2000
Posts: 90,675
Likes: 304
From: SE NY
Cruise-In II Veteran
Re: Code 15 ... how do you fix this one? (Hole-Shot)
Code 15 is set when the coolant temp sensor in the front of the intake base shows a high resistance.
Pull the wiring harness and measure the resistance of the sensor; warm up the engine and measure again. If no change, replace the sensor.
Pull the wiring harness and measure the resistance of the sensor; warm up the engine and measure again. If no change, replace the sensor.
Former Vendor
Joined: Jun 2001
Posts: 7,204
Likes: 6
From: St Marys PA
Re: Code 15 ... how do you fix this one? (65Z01)
I would just rplace the sensor. They are dirt cheap. Hate to say it but the company I was with last made them :bb
I had no part in the design of the parts to my benifit, I just cracked the whip to keep the employees cranking out the parts.
I had no part in the design of the parts to my benifit, I just cracked the whip to keep the employees cranking out the parts.
