rollbar question
Thread Starter
Race Director
Joined: Mar 2002
Posts: 12,968
Likes: 0
rollbar question
if i wanted to make the tubes which extend towards the rear of the car removable, i would weld stubs onto the rear frame and use pins to hold these tubes in place, would this setup be legal (nhra, etc.) for drag racing?
any input would help, as always, thank you boys :cheers:
any input would help, as always, thank you boys :cheers:
Elite Torch Red Member
Joined: Sep 1999
Posts: 57,805
Likes: 23
From: Exit 89 GSP,Lakewood,NJ The Land Of Mojo
Cental/South NJ Events Coordinator
CI 1-2-3-4-5-6-7-8-9-10-11-12 Vet
CI-II Burnout & Drag Champ
St. Jude Donor '03-'04-'05-'06-'07
Re: rollbar question (atotalnincompoop)
No it would not. I'm not sure about using bolts though.
Thread Starter
Race Director
Joined: Mar 2002
Posts: 12,968
Likes: 0
Re: rollbar question (Mr Mojo)
bolts wouldn't be a problem, in fact they would be better and probably what i would end up using anyways :yesnod:
do you think that the fasteners would be the only issue, or do they not want anything removable like that? :cheers:
do you think that the fasteners would be the only issue, or do they not want anything removable like that? :cheers:
Elite Torch Red Member
Joined: Sep 1999
Posts: 57,805
Likes: 23
From: Exit 89 GSP,Lakewood,NJ The Land Of Mojo
Cental/South NJ Events Coordinator
CI 1-2-3-4-5-6-7-8-9-10-11-12 Vet
CI-II Burnout & Drag Champ
St. Jude Donor '03-'04-'05-'06-'07
Re: rollbar question (atotalnincompoop)
I think it's mostly the r movable part. Me personally I would want it to be permanent, I think it's more solid that way.
