406 buildup - part 2 (dialups beware!)
Thread Starter
Former Vendor
Joined: Jun 2001
Posts: 7,204
Likes: 6
From: St Marys PA
406 buildup - part 2 (dialups beware!)
PART 2 continues:
Piston and Rods assembled together:
Piston Top (Weisco Forged)
Accell Manifold I ported out. The nicks are visible on the porting work, but VERY hard to feel: Everything smooth like glass not to mention much bigger.
Manifold measuring: After Porting they are 1 3/4" increased 1/4" !!!
Here is a picture of the manifold ports BEFORE porting ( appears to be 1.5")
Runner I ported and polished.
Runners being measured:
Goto part 3 to see more :thumbs: http://forums.corvetteforum.com/zerothread?id=471077
[Modified by ski_dwn_it, 11:46 AM 1/13/2003]
[Modified by ski_dwn_it, 11:47 AM 1/13/2003]
[Modified by ski_dwn_it, 1:56 PM 1/13/2003]
Piston and Rods assembled together:
Piston Top (Weisco Forged)
Accell Manifold I ported out. The nicks are visible on the porting work, but VERY hard to feel: Everything smooth like glass not to mention much bigger.
Manifold measuring: After Porting they are 1 3/4" increased 1/4" !!!
Here is a picture of the manifold ports BEFORE porting ( appears to be 1.5")
Runner I ported and polished.
Runners being measured:
Goto part 3 to see more :thumbs: http://forums.corvetteforum.com/zerothread?id=471077
[Modified by ski_dwn_it, 11:46 AM 1/13/2003]
[Modified by ski_dwn_it, 11:47 AM 1/13/2003]
[Modified by ski_dwn_it, 1:56 PM 1/13/2003]
