EBL Flash II PNP
Thread Starter
Advanced
Joined: Jan 2023
Posts: 50
Likes: 7
From: Denver
EBL Flash II PNP
Hey everyone,
Gonna be finishing up a top end rebuild this weekend and so I’m thinking it’s finally time to start down the tuning path. I’ve got a Flash II ready to go in but I’m having trouble figuring out if I’m going to need to move pins on my ecm connectors or not. I’ve seen posts saying the crossfire versions needed new connectors and I’ve seen a few posts floating around saying that later models were plug and play.
So my question is which, if any, model years/ecms were plug and play with the Flash II?
(Particularly interested in ‘86 autos, but I’d like a good list for future searchers)
Gonna be finishing up a top end rebuild this weekend and so I’m thinking it’s finally time to start down the tuning path. I’ve got a Flash II ready to go in but I’m having trouble figuring out if I’m going to need to move pins on my ecm connectors or not. I’ve seen posts saying the crossfire versions needed new connectors and I’ve seen a few posts floating around saying that later models were plug and play.
So my question is which, if any, model years/ecms were plug and play with the Flash II?
(Particularly interested in ‘86 autos, but I’d like a good list for future searchers)
Former Vendor
Joined: Mar 2023
Posts: 87
Likes: 38
From: Arizona - One Stop Shop for CFI
I sell the EBL Flash II ECM for the 82/84 CFI vettes. The ECM comes pre-loaded with our stock tune for both years ready to go...PnP 100% with our HAM board installed, ready to go and 100% driveable. No other connectors required for CFI cars. On your vette 86, you do have different connectors with pins, CFI uses an edge card type connector only.
