c4 Camber -3
Thread Starter
Intermediate
Joined: Jul 2023
Posts: 32
Likes: 15
c4 Camber -3
Can anyone post some photos of their front wishbone setup allowing for -2.5 to -3 front camber? I'm at -2.2 and still wearing the outside of my tires too much. I also would like to get the rear close to -2.0
Thanks
Thanks
Drifting
Joined: Jun 2020
Posts: 1,716
Likes: 745
From: Stay dangerous my friends
You can use offset lower control arm bushings that move the lower ball joint outboard a little bit, and as a side benefit the delrin material is very smooth in rotation and virtually no deflection (less camber loss under cornering load)
https://afterdarkspeed.com/product/8...n-bushing-kit/
https://afterdarkspeed.com/product/8...n-bushing-kit/
Race Director
Joined: Jun 2004
Posts: 13,970
Likes: 710
From: WI
That is what I do and you can get the conical spacer pretty thin. I use a bolt and nut adapted into my drill press to turn the spacer then hold a saw against it. Makes a decent cut that way!
