Advice on machining.
#1
Advice on machining.
My 113 heads are in the shop for cleaning, pressure testing and warpage correction (if applicable).
What machining should I have done to accommodate a camshaft with up to .525" lift? Any specs for machining?
I'm trying to stay within a budget, are there a decent set of springs I can get that'll not break the bank?
What machining should I have done to accommodate a camshaft with up to .525" lift? Any specs for machining?
I'm trying to stay within a budget, are there a decent set of springs I can get that'll not break the bank?
The following users liked this post:
'78CorvetteS.A. (01-19-2024)