Two issues with my C68 A/C unit
Thread Starter
Burning Brakes
Joined: Jun 2022
Posts: 844
Likes: 212
From: Florida
Two issues with my C68 A/C unit
Team,
- I have the flashing lights on my A/C unit...whether it's on Auto, Recirculation or Off, I get the blinking light. However, when I run the diagnostic procedure, nothing shows up other than "00". Is this a case of a dirty control board?
- My "Auto" has never worked. If I set it to Auto, nothing happens even when adjusting the temperature. It only works when I increase the fan speed from "0". Any clue as to what is going on?
Thanks,
Ric
- I have the flashing lights on my A/C unit...whether it's on Auto, Recirculation or Off, I get the blinking light. However, when I run the diagnostic procedure, nothing shows up other than "00". Is this a case of a dirty control board?
- My "Auto" has never worked. If I set it to Auto, nothing happens even when adjusting the temperature. It only works when I increase the fan speed from "0". Any clue as to what is going on?
Thanks,
Ric
Safety Car
Joined: Feb 2020
Posts: 4,473
Likes: 1,009
From: Pflugerville, TX
Take it out and clean the buttons on the inside. The C68 controls are very finicky. A few of mine gave me problems sometimes and when I took it apart it did not look dirty. I still cleaned them and never had a problem ever since.
