Intake Manifold
Thread Starter
Advanced
Joined: Dec 2002
Posts: 73
Likes: 0
From: St. Augustine Florida
Intake Manifold
Still in the planning stages of an engine mod. for my 92 coupe. I have been reading one of the top engine builders book on small block engines. There is a section on intake manifolds. Do any of you have any experience or opinions (pro or con) with Lingenfelter's SuperRam?
Safety Car
Joined: Dec 2000
Posts: 3,767
Likes: 5
From: Jacksonville Fl
Re: Intake Manifold (Mikes92)
It's a PITA to install, generally over rated and cost WAAAAAAAAY too much ( unless you buy one cheap off e-bay)
The miniram is a much better alternative. And...if your looking for cheap performance...just cut out about 2-3" of material from the runners in the adjacent runners of the stock TPI base. It will run almost as good as the super ram, but not loose as much bottom end torque.
The miniram is a much better alternative. And...if your looking for cheap performance...just cut out about 2-3" of material from the runners in the adjacent runners of the stock TPI base. It will run almost as good as the super ram, but not loose as much bottom end torque.
Team Owner
Joined: Sep 2001
Posts: 62,128
Likes: 1,727
From: Athens AL
C7 of the Year - Unmodified Finalist 2021
C4 of Year Finalist (performance mods) 2019
Re: Intake Manifold (Mikes92)
Why do you think you need a new intake manifold for a 92? The one youve got right now is perfect and is the same thing as the Miniram.
All you need is a different cam, ported heads, and maybe gears; then youll have all the power you can handle.
I would not even think of using a SR on an LT1.
All you need is a different cam, ported heads, and maybe gears; then youll have all the power you can handle.
I would not even think of using a SR on an LT1.
Race Director
Joined: Jan 2002
Posts: 12,261
Likes: 85
From: O'Fallon Missouri
Re: Intake Manifold (vader86)
Why do you think you need a new intake manifold for a 92? The one youve got right now is perfect and is the same thing as the Miniram.
All you need is a different cam, ported heads, and maybe gears; then youll have all the power you can handle.
I would not even think of using a SR on an LT1.
All you need is a different cam, ported heads, and maybe gears; then youll have all the power you can handle.
I would not even think of using a SR on an LT1.
:iagree:
Team Owner
Joined: Sep 2001
Posts: 62,128
Likes: 1,727
From: Athens AL
C7 of the Year - Unmodified Finalist 2021
C4 of Year Finalist (performance mods) 2019
Re: Intake Manifold (BBA)
Were all 92 'vettes equiped with LT1 motors?
