More clutch questions
Thread Starter
Racer
Joined: Aug 2002
Posts: 253
Likes: 0
From: Strongsville Ohio
More clutch questions
Planned to install a complete single mass set up from Doug Rippie. Found out today that the clutch they sell is a Spec. I've heard so many horror stories on the forum that I'm afraid to try them. Has anyone used the machined Camaro flywheel and the Camaro disc with a Corvette pressure plate? The application is a 91 L98. I have to do something soon, I have to replace the clutch before I start to drive it. Thanks in advance for any input. :banghead:
Team Owner
Joined: Aug 2000
Posts: 40,156
Likes: 45
From: San Pedro CA
Re: More clutch questions (Stingray1970)
your wise to avoid spec... :mad
http://www.corvetteforum.net/c4/nogo/
http://www.corvetteforum.net/c4/nogo/
Burning Brakes
Joined: Dec 2001
Posts: 901
Likes: 15
From: Punta Gorda, FL
Re: More clutch questions (Stingray1970)
Just pulled my Spec clutch as part of my 383 build up. Engine builder called and said the pressure plate was cracked :skep:
The good news: It didn't shatter and remove my feet.
The bad news: The pressure plate is cracked!
FWIW: Going back to stock FW. Like the performance of my aluminum SM, but not worth the noise.
The good news: It didn't shatter and remove my feet.
The bad news: The pressure plate is cracked!
FWIW: Going back to stock FW. Like the performance of my aluminum SM, but not worth the noise.
