[FS] EASE scan tool
Thread Starter
Drifting
Joined: Dec 2000
Posts: 1,851
Likes: 5
From: Liberal Kansas
[FS] EASE scan tool
The C4 (OBD I) is gone. Bought a C5 (OBD II).
For Sale:
EASE Diagnostics scan tool.
PER-GM1-1 GM OBD 1 Enhanced Power train Data Scan Tool Package (GM OBD 1 Cable)
http://www.obd2.com/personal/personal_pricing.htm#per10
http://www.corvetteforum.cc/reviews/...274&TopicID=19
$210.00
dlplett@swko.net
For Sale:
EASE Diagnostics scan tool.
PER-GM1-1 GM OBD 1 Enhanced Power train Data Scan Tool Package (GM OBD 1 Cable)
http://www.obd2.com/personal/personal_pricing.htm#per10
http://www.corvetteforum.cc/reviews/...274&TopicID=19
$210.00
dlplett@swko.net
Thread Starter
Drifting
Joined: Dec 2000
Posts: 1,851
Likes: 5
From: Liberal Kansas
Re: [FS] EASE scan tool (Lionsden)
I have had three responses so far.
Moon 86 posted - first
Corvette Z51 Racer - IM second
JGross email - Third
All the scan tool information I received from EASE is included. The scan tool was used on an '84 with an upgraded (7747) ecm.
Moon 86 posted - first
Corvette Z51 Racer - IM second
JGross email - Third
All the scan tool information I received from EASE is included. The scan tool was used on an '84 with an upgraded (7747) ecm.
Le Mans Master
Joined: Sep 2000
Posts: 6,303
Likes: 714
From: Bartlett IL
Re: [FS] EASE scan tool (Lionsden)
Dan,
Did you sell the Xfire? If nobody else buys the OBD-1 stuff, I think I need the interface. Mine may have gone bad. How much for a lid spacer?
Dominic
Did you sell the Xfire? If nobody else buys the OBD-1 stuff, I think I need the interface. Mine may have gone bad. How much for a lid spacer?
Dominic
Le Mans Master
Joined: Sep 2000
Posts: 6,303
Likes: 714
From: Bartlett IL
Re: [FS] EASE scan tool (Lionsden)
Dan,
Any chance you'd make another lid spacer? I currently have one made of phenolic but the dimensions are as good as the stuff I have seen you make. I am probably going to swap cams again and that would be the right time to sub a new lid spacer.
[Modified by Dominic Sorresso, 9:51 PM 3/6/2004]
Any chance you'd make another lid spacer? I currently have one made of phenolic but the dimensions are as good as the stuff I have seen you make. I am probably going to swap cams again and that would be the right time to sub a new lid spacer.
[Modified by Dominic Sorresso, 9:51 PM 3/6/2004]
