Breathers installation
Thread Starter
Drifting
Joined: Jun 2001
Posts: 1,625
Likes: 1
From: Zagreb, Croatia
Breathers installation
I have two very small air filters siting in garage and I was thinking
of using them as crankase breathers.
Will this small filters be good for crankase breathers?
Should I leave stock PCV in the drivers side valve cover?
of using them as crankase breathers.
Will this small filters be good for crankase breathers?
Should I leave stock PCV in the drivers side valve cover?
Le Mans Master
Joined: May 1999
Posts: 6,513
Likes: 1,301
From: Windermere FL
Re: Breathers installation (Sliding)
Sounds like you could, but do you have a rel reason to change the stocker setup?
I had to go to a PVC breather because I put in a SC, and went with some polished valve covers. So I wanted it all to match.
I had to go to a PVC breather because I put in a SC, and went with some polished valve covers. So I wanted it all to match.
Thread Starter
Drifting
Joined: Jun 2001
Posts: 1,625
Likes: 1
From: Zagreb, Croatia
Re: Breathers installation (Flame Red)
I'll also install chrome valve covers, but main reason why I want to do this is because I did a lot of porting and polishing on heads and intake and I would like to keep that clean as long as possible.
